Machine Operation; Hopper Dumping; After Machine Use; Pushing/Towing The Machine - Nilfisk Floortec R 360 B Bedienungshandbuch

USER MANUAL
ENGLISH

MACHINE OPERATION

1. Avoid stopping for a long time with the machine in the
same position and the brooms rotating: this could
create unwanted marks on the floor.
2. To collect light and bulky debris, lift the front skirt by
pressing the pedal (8, Fig. C); remember that while
the front skirt is lifted, the machine vacuum power
decreases.
WARNING!
When operating on wet grounds, it is
essential to turn off the vacuum system
with the lever (3, Fig. C) to prevent the dust
filter from being damaged.
3. For machine proper operation, the dust filter must be
as clean as possible. To keep the dust filter clean
while sweeping, turn off the vacuum system with the
lever (3, Fig. C), then press the switch (9, Fig. B) for
a while.
During this procedure the main motor and the
vacuum fan are automatically stopped.
After cleaning the filter, push the switch (9, Fig. B)
forward to turn on the main broom and the vacuum
system, then start sweeping again.
While working, repeat the procedure every 10
minutes on average (depending on the dustiness of
the area to be cleaned).
NOTE
When the dust filter is clogged and/or the
hopper is full, the machine cannot collect dust
and debris anymore.
4. The hopper (20, Fig. C) should be dumped after each
working period and whenever it is full (see the
procedure in the next paragraph).
10 FLOORTEC R 360 B

HOPPER DUMPING

1. Stop the machine by releasing the drive pedal.
2. Turn the ignition switch (2, Fig. B) to "0" position.
3. Disengage the hook (21, Fig. C) by pulling its lower
end.
4. Remove the hopper (20, Fig. C) by using the handle
(22), and dump it into special containers.
5. Reinsert the hopper and fasten it with the hook (21).
6. The machine is ready to start working again.

AFTER MACHINE USE

After working, before leaving the machine:
– Lift the side brooms with the lever (4, Fig. C).
– Turn on the filter shaker with the switch (9, Fig. B).
– Dump the hopper (20, Fig. C) (see the previous
paragraph).
– Remove the key from the ignition switch (2, Fig. B).
– Engage the parking brake according to the following
procedure:
– Press the pedal (6, Fig. C) as necessary, then
engage the brake by turning the lever (7, Fig. C)
from (7b) position to (7a) position.
– Release the pedal (6).

PUSHING/TOWING THE MACHINE

To easily push/tow the machine when it is off, proceed as
follows:
– Open the hood (10, Fig. C).
– Turn the switch (19, Fig. U) to "0" and close the hood
(10, Fig. C).
– Push or tow the machine.
– After pushing/towing the machine, turn the switch
(19, Fig. U) to "I".
146 2596 000(3)03-2016