Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Nilfisk FLOORTEC R 360 B Bedienungshandbuch

USER MANUAL
ENGLISH

INTRODUCTION

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with
all necessary information to use the machine properly in a
safe and autonomous way. It contains information about
technical data, operation, storage, maintenance, spare
parts and safety.
Before carrying out any procedure on the machine, the
operators and qualified technicians must read this Manual
carefully. Contact an authorised Nilfisk-Alto Service
Center in case of doubts regarding the interpretation of the
instructions and for any further information.

TARGET

This Manual is intended for operators and technicians
qualified to perform the machine maintenance.

HOW TO KEEP THIS MANUAL

The User Manual must be kept near the machine, inside
an adequate case, away from liquids and other
substances that can cause damage to it.

IDENTIFICATION DATA

The machine model and serial number are marked on the
plate (1, Fig. U) applied on the frame and can be read by
lifting the hood (10, Fig. C).
The machine model year is written in the EC statement
and it is also indicated by the first two figures of the
machine serial number.
This information is useful when ordering machine spare
parts. Use the following table to write down the machine
identification data for any further reference.
MACHINE model .........................................................
MACHINE serial number .............................................
2 FLOORTEC R 360 B

OTHER REFERENCE MANUALS

– Electronic Battery Charger Manual (if equipped), to
be considered an integral part of this Manual
– Moreover, the following Manuals are available:
• Spare Parts List (supplied with the machine)
• Service Manual (that can be consulted at
Nilfisk-Alto Service Centers)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair
procedures must be carried out by qualified personnel or
by Nilfisk-Alto Service Centers listed at the end of this
Manual. Only original spare parts and accessories must
be used.
Contact Nilfisk-Alto for service or to order spare parts and
accessories, specifying the machine model and serial
number.

CHANGES AND IMPROVEMENTS

Nilfisk-Alto constantly improves its products and reserves
the right to make changes and improvements at its
discretion without being obliged to apply such benefits to
the machines that were sold previously. Any change
and/or addition of accessory must be approved and
performed by Nilfisk-Alto.
146 2596 000(3)03-2016