Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Warning:
•
Install the equipment by carefully following the instructions given by the manufacturer and in compliance with the standards in force.
•
All the equipment must only be used for the purpose it was designed for. Comelit Group S.p.A. declines any responsibility for improper use of the apparatus, for modifi cations made by
third parties for any reason or purpose, and for the use of accessories and materials which are not originals.
•
All the products comply with the requirements of Directive 2006/95/EC (which replaced Directive 73/23/EEC and subsequent amendments), as certifi ed by the CE mark they carry.
•
Do not route the riser wires in proximity to power supply cables (230/400V).
•
Do not insert objects or pour liquids into the device.
•
Installation, mounting and assistance procedures for electrical devices must only be performed by specialised electricians.
•
Cut off the power supply before carrying out any maintenance work.
•
Connect the module-holder frame to earth (see Fig.).
•
Do not press and hold the audio hook while the handset is lifted.
•
The camera must not be installed opposite bright light sources, or in places where the fi lmed subject is against the light. To resolve this problem, we
recommend modifying the installation height of the camera, which is usually 160 - 165 cm, to a height of 180 cm and pointing the lens downward so as
to improve fi lming quality.
•
Cameras with colour CCD sensor have poorer sensitivity in low light conditions than black/white cameras. We therefore recommend, in dimly lit
environments, that an additional light source is installed.
General information ............................................................................................................................................................................................19
External unit ........................................................................................................................................................................................................19
Art. 4883 ...............................................................................................................................................................................................................19
Art. 1205/B ...........................................................................................................................................................................................................19
Installing the external unit ..................................................................................................................................................................................20
Internal units ........................................................................................................................................................................................................21
Mounting the Magis internal unit .......................................................................................................................................................................21
Removing the monitor ........................................................................................................................................................................................21
Art. 6402E .............................................................................................................................................................................................................22
Description of monitor ........................................................................................................................................................................................22
Art. 2608 ...............................................................................................................................................................................................................23
Installing door-entry phone Art. 2608 ................................................................................................................................................................23
General installation and operating instructions ..............................................................................................................................................24
Operating distances table ..................................................................................................................................................................................24
Operation .............................................................................................................................................................................................................24
Description of button functions and settings ..................................................................................................................................................25
Settings for monitor Art. 6402E and Style door-entry phone ..........................................................................................................................25
TAB. A Riser addresses ......................................................................................................................................................................................25
Description of functions .....................................................................................................................................................................................25
Additional main or secondary monitors ...........................................................................................................................................................26
Default button settings .......................................................................................................................................................................................26
General button programming warnings ............................................................................................................................................................26
Programming buttons for generic or coded actuator ......................................................................................................................................27
Programming for intercom call ..........................................................................................................................................................................27
Programming/deleting intercom address (selective intercom only) ..............................................................................................................27
TAB. B Selective intercom addresses ...............................................................................................................................................................27
Programming buttons for intercom call ............................................................................................................................................................28
Programming buttons for other functions ........................................................................................................................................................28
TAB.C Riser addresses .......................................................................................................................................................................................29
Programming reset .............................................................................................................................................................................................29
Programming range/ringtones ...........................................................................................................................................................................30
Programming input IN1 for LED/alarm/lock-release/actuator indication .......................................................................................................31
Direct programming of intercom call ................................................................................................................................................................32
Monitor ringtone selection .................................................................................................................................................................................32
Special programming - Art. 4883 .......................................................................................................................................................................33
Wiring diagrams
MSK/018C Basic diagram for two-family kits Art. 8472MC with cascade connection. Switching on/voltage check with system in standby. ......... 114
MSK/013BC Basic diagram for two-family kits Art. 8472MC with branch connection ......................................................................................... 115
MSK/014BC Diagram for two-family kits Art. 8472MC extended with a second Art. 4883. Branch connection. ................................................. 116
MSK/014AC Diagram for two-family kits Art. 8472MC extended with a second Art. 4883. Cascade connection. .............................................. 117
MSK/018/AC Diagram for two-family kit with additional power supply unit Art. 1395 .......................................................................................... 118
MSK/019C Use of remote camera module Art. 1259C ....................................................................................................................................... 119
SB2/AAR Connection of video amplifi er Art. 4833C ............................................................................................................................................120
MSK/HCA Addition of a main monitor in parallel. Cascade connection ..............................................................................................................120
MSK/IC Addition of a main monitor in parallel. Branch connection .....................................................................................................................121
MSK/A20S Cascade connection of third main monitor with local power supply .................................................................................................121
MSK/A23S Branch connection of 2 main monitors and 2 secondary monitors with the same user code ...........................................................122
MSK/A21S Cascade connection of 2 main monitors and 1 secondary monitor with the same user code ..........................................................122
MSK/AAE Connection of additional door-entry phones with branch connection from monitor ...........................................................................123
MSK/AAD Connection of additional door-entry phones with cascade connection from monitor .........................................................................123
MSK/FC Addition of a parallel door-entry phone, with branch connection from riser ..........................................................................................124
18
18
Werbung
Kapitel
Inhaltsverzeichnis
