Electrical Connection - Gram KF 355 Bedienungsanweisung

GB
a risk of frozen items in the cabinet
thawing out.

Electrical connection

The refrigerator/freezer is intended for
connection to alternating current. The con-
nection values for voltage (V) and frequen-
cy (Hz) are given on the nameplate
in the cabinet.
2
Power must be connected via a wall
socket with switch. The wall socket should
be easily accessible.
All earthing requirements stipulated by the
local electricity authority must be obser-
ved. The freezer plug and wall socket sho-
uld then give correct earthing. If in doubt,
approach your local supplier or authorised
electrician.
WARNING
The flexible cord fitted to this appliance
has three cores for use with a 3-pin 13-
amp or 3-pin 15-amp plug. If a B.S. 1363
(13-amp) fused plug is used, it should be
fitted with a 13-amp fuse.
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
of this appliance might not correspond with
the colour marking identifying the termi-
nals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire
to the plug terminal marked "E" or by an
earth symbol, or coloured GREEN or
GREEN-AND-YELLOW. Connect the
BLUE wire to the plug terminal marked "N"
or coloured BLACK. Connect the BROWN
wire to the plug terminal marked "L" or col-
oured RED.
48
All manuals and user guides at all-guides.com
You can change the
door from righthand to
lefthand - hinged or
vice versa yourself
Illustration
change the door from righthand to left-
hand-hinged - or vice versa.
Refrigerator/freezer with one door
(drawing A)
Lay the cabinet on its back with door
uppermost.
Take off the door handle
nary screwdriver.
To take off the door, remove the screws
When the door is removed, one hinge rem-
ains attached to the door. This hinge must
be removed before the door is refitted.
Move the hinge pin
side. Note that the pin must be fitted "op-
posite hand", i.e. it must be turned 1/4 of a
turn (see drg C). It might be necessary to
use pliers to draw the pin out from the top.
Move the dummy hinge
side.
Now replace the door and fit the hinge
accompanying the refrigerator/freezer
where the dummy hinge was fastened.
When refitting the door, a 9 mm spacer
(wood or similar material) should be inser-
ted at the lower hinge, between the front of
the cabinet and the door edge, to create
sufficient clearance for the sealing strip.
Remember to place the correct number of
washers beneath the lower hinge to ensu-
re that the door is at the correct height.
Refit the door handle.
Refrigerator/freezer with two doors
(drawing B)
The procedure is the same as for models
with one door, except that the middle hinge
opposite side after the upper door has
shows how easy it is to
3
2
with a key.
3
must be removed and mounted on the
5
1 using an ordi-
to the opposite
4
to the opposite