Assigning Names To The Sources - JVC kd-dv5000 Bedienungsanleitung

Assigning names to the sources

You can assign names to CDs (both in this unit
and in the CD changer), and the external
component.
After assigning a name, it will appears on the
display when you select the source.
Sources
CDs*
External component Up to 8 characters
* You can assign a name only to conventional CDs.
1
Select a source you want to assign a
name to.
When you select a source, the
SRC
power automatically comes on.
2
While pressing DISP (D), press and
hold SEL (select) for more than
2 seconds.
DISP
D
Ex.: When you select "DISC" as the source
3
Select the character set you want
while the first character position is
flashing.
Each time you press the button,
DISP
the character set changes as
D
follows:
A – Z
(Upper case)
Accented letters
(Lower case)
64
Maximum number of
characters
Up to 32 characters (up to
40 discs)
SEL
a – z
0 – 9 & symbols
(Lower case) (Numbers)
Accented letters
(Upper case)
4
Select a character.
ATT
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps 3 to 5 until you finish
entering the name.
7
Finish the procedure while the last
selected character is flashing.
SEL
To erase entered characters
Insert spaces using the same procedure
described above.
Notes:
• When you try to assign a name to the 41st disc,
"Name Full" appears and you cannot enter the text
entry mode. In this case, delete unwanted names
before assignment.
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
• About the available
characters, see page
78.