Storing Dab Services In Memory - JVC kd-dv5000 Bedienungsanleitung

2
Start searching for an ensemble.
4 to search for ensembles of
Press
lower frequency.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
3
Select a service (either primary or
secondary) you want to listen to.
Press ∞ (down) to select the previous
service (either primary or secondary).
To tune in to a particular ensemble
without searching
Before you start....
1
Press SRC repeatedly to select DAB tuner as
the source.
2
Press and hold SRC repeatedly to select the
DAB band (DAB1, DAB2, or DAB3).
Press ¢
3
ensemble you want is reached.
• If you hold down the button, the frequency
keeps changing until you release the button.
Press 5 (up) or ∞ (down) to select a service
4
(either primary or secondary) you want to
listen to.
74
Press ¢
to search
for ensembles of higher
frequency.
Press 5 (up) to select the
next service. (If a primary
service has some secondary
services, they are selected
before the next primary
service is selected.)
4 repeatedly until the
or

Storing DAB services in memory

You can preset up to 6 DAB services in each
DAB band (DAB1, DAB2, and DAB3) manually.
1
Select the DAB tuner.
1 Press SRC (source)
SRC
repeatedly to select the DAB
tuner.
2 Press and hold SRC. Each
time you press and hold the
button, the DAB band
changes as follows:
DAB1
Notes:
• This receiver has three DAB bands (DAB1,
DAB2, DAB3). You can use any of them to tune
in to an ensemble.
• When using the remote controller, press and
hold FM (DAB). Each time you press the
button, the DAB tuner and the FM tuner is
selected alternately.
2
Tune in to an ensemble you want.
3
Select a service of the ensemble you
want to listen to.
Press 5 (up) to select the next
service.
Press ∞ (down) to select the previous
service.
DAB2 DAB3