Activating The Level Meter - JVC kd-dv5000 Bedienungsanleitung

5
Set the clock system.
1 Select "24H/12H."
2 Adjust "24Hours" or "12Hours."
1
6
Finish the setting.
SEL
To check the current clock time when the unit
is turned off, press DISP (D).
The power turns on and the clock time is shown
for about 5 seconds, then the power turns off.

Activating the level meter

You can show the level meters on the display
while playing any source. This unit is equipped
with three level meter patterns.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press SEL (select) repeatedly until
"METER" selection screen appears
on the display.
Last selected level meter
appears on the display.
SEL
Each time you press the button,
the adjustable items change as
follows:
iEQ
• For iEQ (sound mode) settings, see pages
55 and 56.
• For SEL (basic sound) settings, see page
54.
10
2
ATT
SEL METER
Canceled
2
Select the level meter pattern you
want.
ATT
Meter 1:
The audio level meter fluctuates vertically.
Meter 2:
The speaker on the display vibrates as input
audio level changes.
Meter 3:
The left and right audio level meters appear.
• If the display pattern is changed, only one
audio level meter will be shown.
Off:
No level meter is shown. The source animation
appears.
NOTICE:
The illustrations of the display used in this manual
are mainly of the initial setting when shipped from
the factory. If you have changed the display
patterns or some PSM items, the actual displays
you see will be different.
As you turn the control
dial, the level meters
change as follows:
Off 1
3 2