Assigning Names To The Sources - JVC kd-lh70r Bedienungsanleitung

Assigning names to the sources

You can assign names to CDs (both in this unit
and in the CD changer).
After assigning a name, it will appears on the
display when you select the source.
Sources
CDs*
* You cannot assign a name to CD Text or an MP3
disc.
1
Select a source you want to assign a
name to.
When you select a source, the power
automatically comes on.
2
While pressing D (DISP), press and
hold SEL (select) for more than 2
seconds.
Ex.: When you select CD as the source
3
Select a character.
36
Maximum number
of characters
Up to 32 characters (up to
40 CDs)
CD CD-CH
• See right column for
available characters.
4
Move the cursor to the next (or
previous) character position.
5
Repeat steps 3 and 4 until you
finish entering the name.
6
Finish the procedure while the last
selected character is flashing.
To erase the entered characters
Insert spaces using the same procedure
described above.
Available characters
A B C D E
K L M N O
U V W X Y
4 5 6 7 8
space
Notes:
• When you try to assign a name to the 41st disc,
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
• When the power supply to the memory circuit is
interrupted (for example, during battery
replacement), all the preset settings are erased. If
this occurs, reset the unit (see page 2). Then, assign
names to the sources again.
F G H I J
P Q R S T
Z 0 1 2 3
9
– / < >