Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance - Candy TRIO 9501 Gebrauchs- Und Installationsanweisungen

Vorschau ausblenden Andere Handbücher für TRIO 9501:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 69
$GHQTG ECTT[KPI QWV CP[ ENGCPKPI [QW OWUV 
&KUEQPPGEV VJG CRRNKCPEG HTQO VJG GNGEVTKECN UWRRN[ CPF YCKV HQT CNN VJG JQV RCTVU VQ EQQN
0GXGT WUG CDTCUKXG ENGCPGTU YKTG YQQN QT UJCTR QDLGEVU VQ ENGCP VJG CRRNKCPEG
‡ 7+( (1$0(//(' PARTS :
never use abrasives, scouring pads or sharp objects, as this will cause irreparable damage to the enamel.
Once the appliance has cooled down, simply clean with soapy water and dry with a clean cloth.
‡ 7+( 9,752&(5$0,& +2%
Do not use a sponge that is too wet.
It is advisable to keep away from the hob all substances which are liable to melt, such as plastic items, sugar, or sugar-based products.

Maintenance :

- place a few drops of a specialist cleaning product on the hob surface.
- rub any stubborn stains with a soft cloth or with slightly damp kitchen paper.
- wipe with a soft cloth or dry kitchen paper until the surface is clean.
- Never use abrasive cleaners, wire wool or sharp objects to clean the glass oven door, as this may result in shattering of the glass
Stubborn stains :
- place a few drops of a specialist cleaning product on the hob surface.
- scrape with a scraper, holding it at an angle of 30° to the hob, until the stains disappear.
- wipe with a soft cloth or dry kitchen paper until the surface is clean.
- repeat the operation if necessary.
A scraper with a razor blade will not damage the surface, as long as it is
kept at an angle of 30°. Never leave a scraper with a razor blade within
reach of children.
A few hints :
Frequent cleaning leaves a protective layer which is essential for preventing scratches and wear.
Make sure that the surface is clean before using the hob again.
To remove marks left by water, use a few drops of white vinegar or lemon juice. Then wipe with absorbent paper and a few drops of
specialist cleaning fluid.
The glass ceramic surface will withstand scraping from flat-bottomed cooking vessels, however, it is always better to lift them when
moving.
‡ 29(1 /,*+7,1*
The bulb and its cover are made of material resistant to high temperatures: 230 V~ - E 14 base - 15 W - Temperature 300°C mini.
Replacing the bulb : disconnect the power supply from the oven before attempting to replace the lamp. Wait for the oven to cool down
before doing any operation.
To change a defective bulb, just unscrew the glass cover, unscrew the bulb, replace it with the same type, after replacing the defective
bulb, screw back the protective glass cover.
‡ 7+( ACCESSORIES
The oven shelf - the pastry tray : do not clean the oven shelf with harsh abrasives, scouring pads or sharp objects. Simply use a cloth
wrung out in hot soapy water. Rinse with clean water and then dry.
The drip tray : after grilling, remove the drip tray from the oven and pour the grease into a container. Wash and rinse the drip tray in very
hot water, using a sponge and washing powder. If still stained withs sticky food, immerse in soapy water. The drip tray can be clean
in the dishwasher. Never put the drip tray back in the oven if still dirty.
‡ 7+( 29(1 '225 */$66
It is recommended to wipe the oven door glass with absorbent paper after each cooking cycle. If there is heavy staining, the glass can be
cleaned with a sponge cleaning agent.
‡ 29(1 '225 
it is possible to clean the oven door while in position or after removal.
To remove the door, carry out the following :
. open the door fully,
. release the hooks,
. pull the door upwards, closing it partially, until it is free.
To refit it, make sure you reposition the hinges carefully ; a notch located below them lets you fit he hinges correctly.
After the door is put back on its supports, fit the hinges in their initial position.
‡ *$6 %851(56  for cleaning, it is recommended to remove all greasy or burnt deposits with ammonia based products or usual cleaning
products. Do not immerse the burner caps in cold water immediately after use, to avoid cracking the enamel from the thermal shock. If
the holes become clogged, brush them with soapy water and dry with a cloth.
When re-assembling the burners, make sure that the burner caps and the burners themselves are dry and after, seat them correctly.
‡ &DXWLRQ  Be careful not to let any water get into the burners.
‡ /,'  once the Trio has cooled down, simply clean with soapy water and dry with a clean cloth. Before lifting the lid, make sure that
anything that might spill over has been removed.
7KLV DSSOLDQFH LV PDUNHG DFFRUGLQJ WR WKH (XURSHDQ GLUHFWLYH (& RQ :DVWH (OHFWULFDO DQG (OHFWURQLF
(TXLSPHQW :(((  %\ HQVXULQJ WKLV SURGXFW LV GLVSRVHG RI FRUUHFWO\ \RX ZLOO KHOS SUHYHQW SRWHQWLDO QHJDWLYH
FRQVHTXHQFHV IRU WKH HQYLURQPHQW DQG KXPDQ KHDOWK ZKLFK FRXOG RWKHUZLVH EH FDXVHG E\ LQDSSURSULDWH ZDVWH
KDQGOLQJ RI WKLV SURGXFW
7KH V\PERO RQ WKH SURGXFW LQGLFDWHV WKDW WKLV SURGXFW PD\ QRW EH WUHDWHG DV KRXVHKROG ZDVWH ,QVWHDG LW VKDOO EH
KDQGHG RYHU WR WKH DSSOLFDEOH FROOHFWLRQ SRLQW IRU WKH UHF\FOLQJ RI HOHFWULFDO DQG HOHFWURQLF HTXLSPHQW 'LVSRVDO PXVW
EH FDUULHG RXW LQ DFFRUGDQFH ZLWK ORFDO HQYLURQPHQWDO UHJXODWLRQV IRU ZDVWH GLVSRVDO
)RU PRUH GHWDLOHG LQIRUPDWLRQ DERXW WUHDWPHQW UHFRYHU\ DQG UHF\FOLQJ RI WKLV SURGXFW SOHDVH FRQWDFW \RXU ORFDO FLW\
RIILFH \RXU KRXVHKROG ZDVWH GLVSRVDO VHUYLFH RU WKH VKRS ZKHUH \RX SXUFKDVHG WKH SURGXFW
CLEANING
CLEANING
 *%
30° Maxi

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Trio 9503

Inhaltsverzeichnis