Oil Change / Oil Check; Check The Oil Level; Oil Change - Elmo Rietschle Vlr 1000 Hv+ Originalbetriebsanleitung

7.4

Oil change / oil check

7.4.1

Check the oil level

NOTICE
H Oil filling point with vent screw
I
Oil sight glass
Fig. 18 Change the oil
a) Check the oil levels in the sight glasses (Fig. 18/I) every month.
b) Fill lubricating oil through the oil filling point (Fig. 18/H) up to the middle of the sight glass (Fig. 18/I).
Suitable type of oil: GEAR-LUBE 150
c) Close the oil filling point.
7.4.2

Oil change

CAUTION
If it is not completely emptied, the refilling quantity is reduced.
If you change the type of oil, empty the oil tank completely.
A minimum oil quantity may escape from the vent screw due to pressure compensation.
If larger quantities of oil escape, wash the internal filter of the vent screw.
The waste oil must be disposed of in compliance with the local environmental protection regulations.
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
Property damage due to bad lubrication!
If the oil level is too low, this can cause damages to vacuum pump.
Ø Check oil level regularly and, if necessary, refill oil.
I
MAX
MIN
K
Risk of injury due to slipping and falling!
The floor can be slippery due to leaked oil and cause slipping, tripping or falling.
Ø For oil change wear non-slip shoes.
Ø Remove leaked oil immediately.
H M
K Oil discharge point
M Oil recommendation plate
www.gd-elmorietschle.com © Gardner Denver Schopfheim GmbH
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Maintenance and repair
35
|