Electrical Circuit Components; Instruction To Put In The Battery (Sps - Control) - Parker EO2-FORM F3 Betriebsanleitung

5.4 Electrical circuit components

5.4.1 Instruction to put in the battery (PLC – Control)
NOTE!
i
Change the battery of the PLC - Control every two years! The light diode signals
an empty battery. The battery is behind t he protective cover plate of the
PLC - Control.
All work on the electrical equipment of the machine may be completed only by a
qualified electrician.
WARNING!
In this case never switch off the machine by the main switch, otherwise the
PLC - Control will be irrevocably erased! Never switch off the machine during the
change of the battery!
•
Open the cover flap at the PLC - Control. Pull at the left and right edge (arrows).
•
Remove the battery out of the battery box and pull out the plug out of the section.
•
Put in a new battery.
•
Close the cover plate.
•
Note: The battery needs special disposal of refuse!
Cover plate
Battery
- 54 -
PLC - Control