Button Functions - Renkforce cd 7630 Bedienungsanleitung

Button functions

• Station buttons 1-6 (4)
If you shortly press these buttons, you can select the stations previously stored.
If you want to store the station you are listening to, simply press the desired button for more than 1 second.

Each of the three FM band ranges (FM 1-3) has six station buttons. This means you can assign
18 station buttons.
• AF button (5)
The AF button (5) activates the alternate frequency function.
„AF" is displayed. If the reception of an RDS transmitter station gets weaker or the radio does not receive any RDS
station at all, the display will start flashing. When a station has good reception, the symbol is displayed continuously.
When an RDS station is received, the name of the station is displayed.
When you leave a transmission area, the radio can only automatically switch to a better station if the AF function is
activated.
Regional identification
Hold down the AF button (5) for about 2 seconds until the display shows REG ON or REG OFF. Press the AF button
again to switch between these two modes. The normal display reappears automatically after a few seconds.
If the regional identification is on and the reception gets weaker, the radio will only switch to a different frequency with
exactly the same program.
If the regional identification is off (REG OFF) and the reception gets weaker, the radio switches to a different
transmitter station with the same regional identification.
58
Operating Instructions

English