Mechanical Installation; Installation Position - Renkforce cd 7630 Bedienungsanleitung

Mechanical installation

Most vehicles are already equipped with a car radio slot. The position of the radio slot has been chosen with regard
to safety aspects. Therefore, it is advisable to install the car radio in the designated slot.
The device requires a DIN installation slot with the dimensions 182 x 53 mm. These dimensions are standardized
and usually the vehicle manufacturers keep to them.
If your vehicle is not equipped with a radio slot, please ask your car dealer about the correct place of installation for
your car radio.
Please choose the place of installation carefully so that the device neither influences the
driver's activity nor distracts him/her from traffic.
Only use the provided installation material to guarantee a safe installation.
Any changes to the vehicle that become necessary for the installation of the CD tuner or other
components must be carried out so that neither the roadworthiness nor the stability of the car
are affected. With many cars, the operating licence will lapse if a part of sheet metal is cut out.
Since the device produces heat during operation, the place of installation must be heat-
resistant.
Before drilling attachment holes, make sure that no electric cables, brake lines, the fuel tank or
similar are damaged.
When you use tools to install your car hi-fi components, observe the manufacturer's safety
instructions.
When installing the car hi-fi system, take into consideration the risk of accident which can arise
from devices being torn away in the case of an accident. Therefore, fasten each part securely
in a location where it will not pose a risk to the passengers.

Before you install the device, check the depth of the designated installation slot.

Installation position

The angle of installation to the horizontal must be smaller than 30°. If the device is tilted too much, CDs might not
be played back properly.
43