Renkforce cd 7630 Bedienungsanleitung Seite 60

• BAND button (10)
Use this button to select the band range of the radio unit. There are 3 FM ranges:
FM1 > FM2 > FM3

On each of the three band ranges, 6 stations can be stored on station buttons 1-6 (4).
and buttons (11)
•
With these buttons the receiving frequency can be changed to adjust stations in radio mode.
By shortly pressing a button, the frequency is changed manually step by step.
By holding down a button, you activate station search. The search will stop at the next station with a good signal.
• A/PS button (12)
If you press this button shortly, the stations stored on station buttons 1-6 (4) are played for 5 seconds each. To stop
this, press the button again.
When you keep the button pressed, all stations that can be received well are stored on station buttons 1-6 (4).
After this procedure, the stored stations are played for 5 seconds each, as described above.
• SCAN button (13)
This button starts station search.
When a station has been found, it is played for 5 seconds and then station search continues.
Press the button again to stop station search and to listen to the current station.
60
Operating Instructions

English