Button Functions - Renkforce RUCD-1804 Bedienungsanleitung

Button functions

BND / ID3 button (12)
• Push this button to select the band range of the radio unit.
• There are 3 FM ranges:
FM1 > FM2 > FM3
On each of the three band ranges, 6 stations can be stored on the station button 1-6 (13-18).
Buttons (1) and
• With these buttons the receiving frequency can be changed to adjust stations in radio operation.
• Briefly pushing a button starts the automatic station search.
• The auto-scan only stops at the next station that can be received well.
• By pushing a button longer, you activate manual station scan.
• The display shows MANUAL.
• In this mode, the frequency is changed until you release the corresponding button again. Brief pushes of this button
changes the frequency step by step.
If buttons are not pressed for an extended period of time, the devices switches back to automatic station
search. The display shows AUTO.
Station buttons 1-6 (13-18)
• If you briefly push these buttons, you can select a station you have pre-set.
• If you want to store a station you are listening to, simply push the desired button for approx. three seconds.
Every one of the three FM ranges (FM1-3) has six radio station buttons. Therefore you can assign 18 sta-
tion buttons.
F/PS button (8)
• Keep this button pushed to activate automatic station search. All stations that can be received well are automatically
stored for the station buttons 1-6 (13-18).
After this procedure, the stored stations are played for a few seconds.
• Push this button only briefly to play every saved station for a few seconds (same function as after automatic station
storage).
• To permanently play back a station, push the button F/PS (8) again briefly.
42
(7)