Service; Safety Instructions For Cordless Dry Diamond Drills; Operating Personnel Requirements; 2.7.2 Safety Instructions For All Work - Baier ABDB 82 Original Bedienungsanleitung

g) Follow all charging instructions and never
charge the rechargeable battery or the
cordless tool outside the temperature range
given in the instruction manual.
Incorrect charging or charging outside the
approved temperature range can cause
irreparable damage to the rechargeable battery
and increase the risk of fire.
2.6

Service

a) Have your power tool repaired by qualified
personnel only and use original spare parts
only.
This will ensure that the safety of the power tool
is maintained.
b) Never service damaged rechargeable
batteries.
All servicing of rechargeable batteries should
only be carried out by the manufacturer or
authorised customer service agents.
2.7 Safety instructions for cordless
dry diamond drills
2.7.1 Operating personnel
requirements
•
People below the age of 16 may not use the
machine.
•
The operating personnel must be familiar
with the content of this instruction manual.

2.7.2 Safety instructions for all work

•
Wear hearing protection when hammer
drilling/diamond drilling.
Exposure to noise can cause loss of hearing.
•
Use the additional handle(s).
Loss of control can result in injuries.
•
Support the power tool properly before
using.
This power tool produces a large torque. If the
power tool is not properly supported during use,
the use can loose control of it and injuries can
occur.
ABDB 82, V01 / 2021-03

2.7.3 Workplace safety

•
Secure the work area also behind openings
and cutouts.
Unsecured work areas can endanger you and
other people.
•
Watch out for open and concealed electricity
cables, and water and gas pipes. Use
suitable detectors to find concealed utility
pipes and cables, or contact the local utility
company for advice.
Contact with electricity cables can cause fires
and an electric shock. Damage to a gas pipe
can cause an explosion. Penetrating a water
pipe causes damage to property or could cause
an electric shock.
•
Do not use the power tool near flammable
materials.
Sparks could ignite these materials.
•
Secure the workpiece.
A workpiece securely held in clamping devices
or a vice is more safely held than in the hand.
•
Avoid dust accumulation in the workplace.
Dusts can easily ignite.
•
Ensure adequate ventilation in closed
rooms.
Risk due to dust and impaired vision.
•
Inform and consult the responsible
structural engineer, architect or the
responsible site engineer about planned
drilling.
Cut through reinforcement only with the approval
of a structural engineer.
•
When drilling through walls or ceilings,
ensure that people and work areas on the
other side are protected.
The core drill bit / socket outlet drill bit can
protrude beyond the drill hole and the drilled
core can fall out on the other side.
•
Before drilling holes drilling objects, check
the rooms concerned for obstructions and
block off this area. Use formwork to secure
the drill core against falling.
| 29 |