Standalone Mode - JB-Lighting P4 Bedienungsanleitung

P4
LAMP POWER
The P4 offers 2 different lamp power modes. The STANDARD mode offers 280W lamp power
with a max. operating time of 2000 hours and the ECO mode offers 224W lamp power and a max
operating time of 3000 hours.
SHORTEST DISTANCE
This setting is for the colour wheel and for the Gobowheels. Switched to ON (default) it always
take the shortest route from one colour/gobo to another. Switched to OFF it routes only from the
first color/gobo to the last color/gobo and backwards.
WLJB DMX HOLD
The behavior of the P4 in case the Wireless DMX connection is interrupted can be set to:
1. DMX Hold - P4 freezes on the last received DMX value.
2. Fade out - P4 fades out after 5 seconds.
On return of the DMX signal the P4 first turn to its new position and fades in.

5.6 STANDALONE mode

A sequence, up to 20 steps, consisting of preprogrammed cues can be recalled by means of
the STANDALONE MODE. The sequence will run as a loop. Cues can be entered in two different
ways. The first way is to program every feature by means of the key of the units onboard control
panel. The second way is to program the cues by means of a connected DMX control console
and to store them in the fixture.
IMPORTANT! The functions MODIFY, RUN and REMOTE can be accessed only by pressing a
combination of keys and not just by pressing „ENTER". Before activating the functions make
sure that there is just one DMX-transmitter in the DMX-line (e.g. one control console or one
master fixture). A number of DMX-transmitters can damage the DMX driver of the fixtures. To
enter the functions press "ENTER" (keep it down) and press „ESC" in addition.
Programming the stand alone sequence:
Enter the menu STANDALONE -> EDIT. STEP NR 01/01 will be displayed. Enter the MODIFY
menu to get access to the fixtures functions. Recall the functions and enter DMX values. Enter
FADE TIME (during which the effects will move to the programmed position) Enter NEXT TIME
which will be the duration of the step. Add a new step with INSERT. The DMX values of the last
step will be automatically copied to the new step. With DELETE one step of the sequence can
be deleted. Choose the step and confirm the function with ENTER. To reset the DMX values of a
step use RESET STEP. Select the step and confirm with "ENTER". All DMX values of the step will
be set to zero. With CLEAR ALL the complete sequence will be deleted and the display will show
STEP 01/01
Store cue's from a DMX controller:
The DMX values can also be programmed by means of a DMX console. Enter the STANDALONE
menu and navigate to CAPT DMX. Program the DMX values with an external DMX console. To
capture the data press „ENTER". The fixtures display will show START CAPTURE. To insert, de-
lete or reset use the keys of the control panel of the fixture.
Activate the standalone mode:
The standalone mode is activated in the menu STANDALONE -> RUN. To enter the functions
press "ENTER" (keep it down) and press "ESC" in addtion. P4 will execute sequence in a repea-
ting loop. To leave press "ESC" and hold it down and press "ENTER" in addition.
- 45 -