Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
P4
5.2 FACTORY DEFAULTS
To set back the P4 to factory defaults choose in the menu FACTORY DEFAULT -> LOAD
DEFAULTS. After confirming SURE? with „ENTER", the personal settings of the P4 will be set
back to factory defaults.
5.3 USER DEFAULTS
If personal settings are done in the PERSONALITY menu, the user can save and reload it in the
USER DEFAULTS menu. To make sure that the personal settings are not changed quickly on a
stage, the save progress is locked with the password „JB-LIGHTING".
5.4 DMX ADDRESS
Change the DMX address directly by pressing the keys „UP" and „DOWN". Confirm and store it
by pressing key „ENTER". The DMX address can also be changed in the menu DMX ADDRESS.
5.5 PERSONALITY
DMX INPUT MODE
The P4 provides an embedded radio-DMX receiver. The receiver works with the JB-Lighting
Wireless TRX transmitter. To enable the P4 to receive radio-DMX change the menu from WIRED
(factory default) to WIRED/WIRELESS. The fixture needs to be logged in to the Wireless TRX
transmitter. To log-in press the „Start" button (see also manual Wireless TRX). The radio chan-
nel is displayed when the P4 is logged. The main display will show the intensity of the incoming
signal. If the P4 is connected either via DMX cable and radio-DMX, the cable signal has priority.
DMX MODE
The P4 offers 3 different operating modes (see DMX protocol on page 47). Mode 1 is an 8
bit mode (8 bit for all features; PAN/TILT 16bit), in this mode you can control all features of your
P4 using less channels. For using relevant channels in 16bit use the mode 2. This mode is for
smoother operation with the P4. The mode 3 is a compressed mode to reduce the channels to
a minimum.
PAN / TILT
RESOLUTION sets pan and tilt to 8 bit or 16 bit control resolution. The default setting is 16 bit.
If this fine resolution is not required, you can set to 8 bit for quicker operation of pan/tilt values.
The PAN INVERS and TILT INVERS commands invert the direction of pan and tilt. The PAN/TILT
SWAP command sets pan commands to tilt and vice versa.
CURVES
The curve can be adjusted for the dimmer channel. There is a square-law curve for finer control
at low intensity and coarser control at high intensity and a linear-law curve available.
LAMP ON/OFF DMX
With this option you can select if it's possible to switch on/off the lamp via DMX. Default value
is on.
LAMP MODE
There are three options available in this menue item.
AUTO START means that the lamp switches automaticall on if the fixture is powered on.
AUTO OFF means that the lamp switches not on if fixture is powered on.
AUTO DMX means that the lamp switches on if the P4 receives a DMX signal and the lamp is
turned off when there is no DMX signal longer present.
- 44 -
Werbung
Inhaltsverzeichnis
