Set To Factory Default; Dmxaddressing; Standalone Mode - JB-Lighting VaryLED 3*84 Bedienungsanleitung

3.2 Set to factory default

To set back the VaryLED 3*84 to factory setting press key "Menu" one time.
FACTORY DEFAULT
default menu. Select
be displayed. Confirm by pressing key "Enter" again. The personal setting of the
V aryLED 3*84 will be set back to factory default.
3.3 DMX Addressing
Enter DMX address by means of the keys "+" and "-". Confirm a store by pressing
key "Enter".

3.4 Standalone mode

A sequence consisting of preprogrammed cues can be recalled by means of the
Standalone mode. The sequence will run as a loop. Cues can be entered in two
different ways. The first way is to program every feature by means of the key of
the units own control panel. The second way is to program the cues by means
of a connected DMX control console and to store them onb-oard of the VaryLED.
Enter DMX values by means of the control panels keys:
Recall standalone mode:
Press key "Menu" first. Then press key "+" five times (see page 24),
STANDALONE STEPS will be displayed. Confirm by pressing key "Enter"
STEP NR. 1/1, will be shown. Confirm again by pressing "Enter"
After this second confirmation the display will show: MODIFY 1/1
Now recall Modify Menü by pressing key "Enter".
The Modify menu enables access to all parameters of the unit. Use key "+" and "-"
to recall the desired parameter. Confirm choice by pressing "Enter". Enter DMX
values by means of the keys "+" and "-". Store DMX values by pressing "Enter".
To escape press key "Menu".
Add one step to the sequence:
Press key "+" until menu
SURE ? will be displayed. Confirm by pressing key "Enter" again.
A new step will be added to the sequence.
The DMX values of the last step will be automatically copied to the new step.
To alter DMX values enter Modify menu and proceed like describe in chapter:
Enter DMX values by means of the control panel keys.
Delete one step of a sequence:
Recall the Standalone menu.
Confirm by pressing key "Enter".
Use keys "+" and "-" to recall the desired step. Confirm selection by pressing key
"Enter". Select menu
by pressing key "Enter".
key "Enter" and the selected step will be deleted.
JB-lighting Lichtanlagentechnik GmbH Sallersteigweg 15 D-89134 Blaustein Telefon +49 (0)7304-9617-0
will be displayed. Press key "Enter" to enter Factory
LOAD DEFAULTS and press key "Enter".
INSERT is shown. Confirm by pressing key "Enter".
STANDALONE STEPS
STEP NR: 1/X
DELETE by pressing key "+". Confirm the selection of the step
SURE? will be displayed. Now confirm again by pressing
SURE ?
must be shown on the display.
will be displayed.
will
23