Info - JB-Lighting P4 Bedienungsanleitung

P4
Operation in Master-Slave mode:
To set a fixture to slave-mode navigate to REMOTE. To activate the slave funciton press "ENTER"
(keep it down) and press "ESC" in addtion. The display will show either REMOTE INACTIVE if
no DMX-signal is being received or REMOTE ACTIVE if a DMX-signal is being received. To leave
this function press "ESC" (keep it down) and press "ENTER" in addition. Connect the P4 with
DMX cables. Select STANDALONE -> RUN with the master fixture. Start function by pressing
"ENTER" (keep it down) and pressing "ESC" in addition. All connected fixtures will repeat the
steps synchronized to the master fixture. To leave the menu press "ESC" (keep it down) and press
"ENTER" in addition. If you realize that a fixture reacts inaccurate check if the display shows
REMOTE ACTIVE.

5.7 INFO

The menu informs about the current software/firmware version. The non-resettable TOT
OPERATE TIME counter displays total hours of use since the P4 was manufactured. Lamp time
shows the total operation time of the lamp, it's resetable if you change the lamp to have a timer
for the lamp life. Lamp ignit shows the number of ignitions of the lamp. It's also resetable. Tem-
perature readouts from the P4 base (TEMP BASE LCD) and from the P4 head (TEMP HEAD) are
available. In each case, you can view the current temperature and the maximum temperature
reached since the readout was last reset individually.
- 46 -