Entering Dimensions In The Motorcycle Programmes; Wheel Spin - Corghi EM 9250 CompactLine Betriebsanleitung

ALU 2P
15
15a
5. ENTERING DIMENSIONS
IN THE MOTORCYCLE
PROGRAMMES
The operations described below are valid if the motor-
cycle setting (byke) has been activated in the "vehicle
type" set up.
- Fit the appropriate extension on the inner measuring
arm, specifically extension A on machines with no weight
holder or extension B on machines with weight holder
(Fig.16).
UK
16
- To acquire the wheel dimensions, follow the instructions
in the paragraph "Entering wheel dimensions".

6. WHEEL SPIN

Wheel spins take place by pressing the key.
WARNING
To obtain the most accurate results, we recommend not improperly solicit the wheel balancer
during the spin.
CAUTION
If the wheel keeps spinning permanently due to a fault on the machine, switch off the
EM 9250 CompactLine Operator's manual 91