Iberital Expression Pro Installations- Und Betriebshandbuch Seite 79

NOTE
If our model only has a 2-position main switch (ON-OFF), when it is switched on the boiler will begin to
fill, if not already full. When the machine detects that the minimum level of water has been reached, it will
begin to heat the water to make the coffee.
2.3.1. Programming dose on the control unit (not available on semi-automatic
versions)
In order to program the dose you must press the 'non-stop' button on the left button pad (group 1) for 5 seconds, and
the non-stop coffee LED will come on (*).
Iberital IB7
NOTE
If you have already entered programming mode and do not press any button to indicate a dose within
30 seconds, the button pad will go to stand-by position.
At this point programming can be started for the four coffee selections. When the desired quantity of coffee is obtained,
press the selection once again and the dosing will stop. The same operation will have to be followed for all buttons.
By carrying out this process all the groups will be programmed automatically.
NOTE
If we wish, we can operate in the same way for other groups, in order to set a customised dose for each
of the groups.
Iberital IB7
The selections that are already programmed will appear with their LEDs off. When this happens it is still possible to
modify the dose in the same manner as indicated above.
INSTALLATION AND OPERATION MANUAL
Iberital Intenz Iberital Tandem
Iberital Intenz Iberital Tandem
IBERITAL
New Iberital / Expression Pro
New Iberital / Expression Pro
77