Guidelines For Setting Up A Raid - Bosch DVA-08E Schnellstartanleitung

RAID Subsystem DVA-08E, -08K, -16K
10.2
Bosch Sicherheitssysteme GmbH
Downloaded from www.Manualslib.com
8. In the navigation tree, click Configuration, and then click Configuration Parameters
9. In the Configuration Parameters pane, click the Communication tab.
10. In the IP Address box, type the new IP address.
11. In the Subnet Mask box, type the new subnet mask.
12. Click Apply to open a dialog box where you accept the changes.
13. Click OK.
NOTICE!
For security reasons we also recommend changing the passwords of the access levels for
Configuration and Maintenance. In the Configuration Parameters pane, click the Password
tab, and then change the passwords accordingly.
The password for the access level Information is 1234 (default) and cannot be changed.

Guidelines for Setting up a RAID

To change the factory default settings and the optional settings, use the following procedure.
To create a logical drive:
1. Click the Windows Start button, point to All Programs, point to Bosch, and then click
Bosch RAIDWatch. The applications opens log on dialog box.
2. In the navigation tree, click Configuration, and then click Create Logical Drive.
3. Click the physical drives from the Front View pane, that are used in the Logical Drive. The
Selected Members pane displays the disk drives slot IDs and sizes.
4. In the RAID Level list, click a raid level.
5. In the Stripe Size list, click a stripe size. We recommend using a stripe size of 16k.
6. In the Initialization list, click On-line if the storage should be available immediately for
the host. Or, click Off-line if the storage should be available after initialization is finished.
7. In the Write Policy list, click Default.
8. Click OK. The application opens a dialog box where you accept the changes.
9. Click OK to create a logical drive.
To add partitions:
1. In the navigation tree, click Existing Logical Drive.
2. In the Logical Drives pane, select the logical drive you want to partition.
3. Right-click the selected logical drive, and then click Edit Partition. The application opens
the Edit Partition dialog box.
4. Right-click the partition bar, and then click Add Partition. The application opens the
Partition Size dialog box.
5. Type the desired capacity, and then click OK. Some DVRs only support a maximum
capacity of 2 TB.
6. Close the Edit Partition dialog box.
7. In the Write Policy list, click Default.
8. In the Password box, type the password if needed.
9. Click Apply.
NOTICE!
For Bosch DVRs it is not necessary to create Logical Volumes.
To add host LUN mapping:
1. In the navigation tree, click Host LUN Mapping.
2. Right-click the Host LUN Mapping pane, and then click Add LUN Map. The application
opens the Add new LUN to host dialog box.
3. In the Channel ID(s) box, select the Channel ID you want to use.
manuals search engine
Changing the Configuration via a Web Browser | en
Quick Installation Guide
83
F.01U.027.800 | V5 | 2010.06