Using Bosch Raidwatch On The Host Computer; System Requirements - Bosch DVA-08E Schnellstartanleitung

RAID Subsystem DVA-08E, -08K, -16K
11
11.1
Bosch Sicherheitssysteme GmbH
Downloaded from www.Manualslib.com

Using Bosch RAIDWatch on the Host Computer

Bosch RAIDWatch allows you to administrate multiple subsystems from your host computer.
We recommend the installation on a host computer if central management of multiple
subsystems is required.

System requirements

Before starting the installation, read through the notes listed below:
– TCP/IP must be installed and running with a valid IP address assigned to a server. The
server can either be used as a centralized management station, a remote client using a
browser to access the array, or directly attached with a RAID subsystem using the in-
band protocols.
– Your system display must be running in 256 colors or a higher mode otherwise some
configuration items may not be visible. Screen size of 1024 x 768 is recommended to
avoid any graphic transformation
– Check to confirm that the RAID disk arrays and controllers are installed properly. For the
installation procedure, see the documentation included with the controller/subsystems.
Server Running Bosch RAIDWatch
– Computer must be a Pentium or above PC-compatible running Windows 2000/XP and
Windows 2003 that supports Java Runtime 1.4.2 or higher.
– 256-color or higher mode management station monitor.
– At least one available RS-232C port is required (if connection to the controller is through
the RS-232C).
NOTICE!
Bosch RAIDWatch allows you to select several options during the installation process.
However, it is recommended that all default combinations be retained. This installation guide
only describes the installation process using the default settings.Please refer to your Bosch
RAIDWatch User's manual for further requirements and restrictions.
manuals search engine
Using Bosch RAIDWatch on the Host Computer | en
Quick Installation Guide
85
F.01U.027.800 | V5 | 2010.06