Subsystem Cable Connections; Power Cables; Host Channels - Bosch DVA-08E Schnellstartanleitung

RAID Subsystem DVA-08E, -08K, -16K
7
7.1
7.2
Bosch Sicherheitssysteme GmbH
Downloaded from www.Manualslib.com

Subsystem Cable Connections

Power Cables

1. Connect the provided power cables to the power sockets on the back of the system (see
Figure 7.1 and Figure 7.2). For DVA-08E one (1) power cable is needed and for DVA-08K
and DVA-16 K two (2) power cables are needed.
DVA-08E
Figure 7.1 Controller Module DVA-08E
DVA-08K / DVA-16K
Figure 7.2 Controller Module DVA-08K / DVA-16K
2. Make sure the power source is within the correct power range (100 to 240 VAC) prior to
powering on. Auto-ranging is supported by the power supply modules.
3. Plug the other end of power cords into the power source.

Host Channels

1. The DVA-08E comes with one (1) and the DVA-08K and DVA-16K with two (2) dual-stack
VHDCI host connectors on the controller module's faceplate. One (the "In" port) can be
connected to an external host computer or DVR. Another (the "Out" port) can be used for
Daisy Chain to connect another subsystem (see Figure 7.3, Figure 7.4, and Figure 7.5).
The DVA-08E does not support daisy chaining.
Make sure to use the correct cable for your host computer or DVR (see
Section 12 Connecting a Digital Video Recorder).
DVA-08E
Figure 7.3 Controller Module DVA-08E
manuals search engine
Quick Installation Guide
Subsystem Cable Connections | en
F.01U.027.800 | V5 | 2010.06
79