Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
yyyyy
Section 6: Appendices
Receive One Setup (43h)
SYS_HEAD 43(h), vv(1)1, vv(1)2, vv(2)1, vv(2)2, xx1, xx2, yy1, yy2, zz(1)1, zz(1)2, zz(2)1, zz(2)2,
dd(1st)1,dd(1st)2, ... dd(nth)1, dd(nth)2, F7(h)
vv
When xx = 00(h)
When xx = 01(h)
yy
zz
dd(n)
The Receive One Setup procedure is used to load a Setup into the DDP. The number of setup bytes to be
received (n) is different for each setup. If the DDP is sent a Receive One setup procedure where the setup num-
ber is not a valid RAM destination, it will be ignored.
Request Bulk Dump (49h)
SYS_HEAD, 49(h), F7(h)
When a Request Bulk Dump procedure is received, the DDP will respond with a Receive Bulk Dump procedure.
Receive Bulk Dump (48h)
SYS_HEAD 48(h), dd(1st)1 dd(1st)2, ... dd(nth)1, dd(nth)2, F7(h)
dd(n)
The Receive Bulk Dump procedure is used to load all User Programs into the DDP. A software version number is
imbedded in the data.
Receive Key Scan Code (54h)
SYS_HEAD, 54(h), cc, F7(h)
cc
The Receive Key Scan Code procedure is used to emulate a button press on the front panel of the DDP. See the
Key Scan Code Maps for a list of Key Scan codes. The device will respond with a Receive Key Accepted proce-
dure.
Key
Next
Select
yyyyy
Prev
Encoder up*
Encoder controls are included, to allow you to emulate encoder moves as well as button presses.
** Config is included to make it accessible through SysEx commands even though it is not represented by its own
button.
34
Downloaded from
www.Manualslib.com
.software version number
Dual Mono is selected
Linked Type is selected
The Setup number, 1-100 (00-63h)
Byte Count
Program data
.Bulk Dump Data
Code for the Key Scan (note: there is only one byte, not two)
Code
Key
01h
Gate
05h
De-ess
09h
Prog
0Dh
Encoder down* 0Eh
manuals search engine
Code
Key
02h
Comp
06h
S/EQ
0Ah
Store
Config**
Code
Key
03h
Lim
07h
Util
0Bh
Bypass
0Fh
Code
04h
08h
0Ch
*
Werbung
Kapitel
Inhaltsverzeichnis
