Replace Old; Store New - Harman dbx DDP Bedienungsanleitung

yyyyy
Section 5: Utility Functions

Replace Old:

Notice that as you write over an old setup, all other programs that recall that setup will now recall the
newly saved setup.

Store New:

yyyyy
Downloaded from www.Manualslib.com
1. To replace an old setup, move the curser to the Replace Old choice and press Store. You
are given a choice of which setup to replace. Using the Data Wheel scroll to the name of
the setup you wish to replace with your new setup. Press Store.
2. After a brief pause, the screen will display the text, "Done!!", and you have saved a setup over
the old setup that you chose. If you wish to save your setup to a new spot without erasing any
other setups use the following instructions:
1. To store a new setup, choose Store New after pressing the store button. Again, you must
name your new setup. After you are done, press Store once again. You now must choose a
place for the new setup to be placed in the setup library. The name of your new setup is dis-
played on the middle line of text (the "Parameter 2" spot).
2. Use the Data Wheel to scroll to the place where you want to the new setup added. As you
scroll, notice the names of the setups already in the library scrolling by on text lines 1 and 3
(parameter 1 and parameter 3). This indicates that you are placing your new setup between the
two setups displayed above and below your new one. The DDP "makes room" for your setup,
no matter where you want to place it.
3. Pressing Store once more saves the setup in the spot you chose, and after a brief pause, the
screen display the "Done!!" line and you have saved a setup, complete with all parameters,
ready to use next time.
NOTE: T
O USE YOUR NEW
manuals search engine
S ,
ETUP IT MUST BE RECALLED INTO A
P .
ROGRAM
23