Changing Chain Types; Saving Programs And Setups; Saving A Program - Harman dbx DDP Bedienungsanleitung

yyyyy
Section 4: Editing/Saving/Recalling Programs
To increase the sustain of a musical instrument (e.g., a guitar or bass), use the sidechain circuit and boost the EQ
in the dominant frequency range of the instrument, along with a fairly low threshold and a moderate compression
ratio.
The sidechain path may also be used to reduce the effects of low frequencies on the compressor. Using the EQ to
de-emphasize low frequencies allows the detectors of the gate, compressor, and limiter elements to react only to
the more musical parts of the audio signal. This method greatly reduces the "pumping and breathing" that can
occur in compressors.
The in-line 3-band parametric EQ works in the same way as the sidechain EQ. It is a 3-band parametric EQ that
has variable Q and a +/-12dB boost or cut ability in each of the 3 bands

CHANGING CHAIN TYPES

Users who wish to configure the DDP "from the ground up" may do so. While in program mode and on any pro-
gram number you may press, hold, and release the Program button to enter the CONFIG SETUP mode. This
takes you to a screen that says "Config Setup" in the top text line under the program number. In the second line
of text you will see the cursor and the current chain in any stereo setup. You can scroll between chain types and
choose one of them for your setup by pressing the store button.
If you are using a dual mono program, the screen will allow you to choose two different chain types from among
the 6 chain choices. Once you have chosen the chain types, you will need to store the new program you have
created. You may save your work at any time. If you like to live dangerously, just save before you finish the ses-
sion, or save more often, it's up to you. The store LED will light as you scroll to new chains, indicating that you
must press store in order to make the current selection active in the program you are in. After you have pressed
store, press program again and you will return to program mode. You will need to setup each element of the pro-
cessing chain. Note that when you choose to create a setup from the user config menu, all the parameters of the
chain are turned to the nominal or off position, depending on the parameter.

SAVING PROGRAMS AND SETUPS

Saving a program

The most important part of saving your processing library is realizing the following
Figure 21: Store program
PARAMETERS ARE ASSOCIATED ONLY WITH SETUPS, NOT WITH PROGRAMS
yyyyy
Saving a program is done by following these steps:
1. Press the Store button. The screen looks something like this.
2. You have the choice of saving the Program, or Saving the setup. Choose the first option by simply
pressing the Store button while the curser is in front of the word "Prog".
3. As you do this, the screen goes to the next save page, asking you to name the new program. The
curve window shows instructions. Using the Data Wheel as a "selector" and the Page Up / Page Down
buttons as the cursor, create the name you want to use, then press the store button to save the name.
Downloaded from www.Manualslib.com manuals search engine
21