Safety Instructions - ZANKER KOB57602 Benutzerinformation

• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
glass door since they can scratch the surface, which may result in shattering
of the glass.
• Excess spillage must be removed before the pyrolytic cleaning. Remove all
parts from the oven.
• To remove the shelf supports first pull the front of the shelf support and then
the rear end away from the side walls. Install the shelf supports in the oppo-
site sequence.

Safety instructions

Installation
Warning! Only a qualified person must install this
appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the ap-
pliance.
• Always be careful when you move the appliance be-
cause it is heavy. Always wear safety gloves.
• Do not pull the appliance by the handle.
• Keep the minimum distance from the other applian-
ces and units.
• Make sure that the appliance is installed below and
adjacent safe structures.
• The sides of the appliance must stay adjacent to ap-
pliances or to units with the same height.
Electrical connection
Warning! Risk of fire and electrical shock.
• All electrical connections should be made by a quali-
fied electrician.
• The appliance must be earthed.
• Make sure that the electrical information on the rat-
ing plate agrees with the power supply. If not, con-
tact an electrician.
• Always use a correctly installed shockproof socket.
• Do not use multi-plug adapters and extension ca-
bles.
• Make sure not to cause damage to the mains plug
and to the mains cable. Contact the Service or an
electrician to change a damaged mains cable.
• Do not let mains cables to come in touch with the ap-
pliance door, specially when the door is hot.
• The shock protection of live and insulated parts must
be fastened in such a way that it cannot be removed
without tools.
• Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
• If the mains socket is loose, do not connect the
mains plug.
• Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.
• Use only correct isolation devices: line protecting
cut-outs, fuses (screw type fuses removed from the
holder), earth leakage trips and contactors.
• The electrical installation must have an isolation de-
vice which lets you disconnect the appliance from
the mains at all poles. The isolation device must
have a contact opening width of minimum 3 mm.
• Fully close the appliance door, before you connect
the mains plug to the mains socket.
Use
Warning! Risk of injury, burns or electric shock or
explosion.
• Use this appliance in a household environment.
• Do not change the specification of this appliance.
3