ZANKER KOB57602 Benutzerinformation Seite 19

Problem
The display shows F102.
The oven does not heat up. The
display shows Demo.
The display shows an error code
that is not on this list.
Steam and condensation collect on
the food and in the oven.
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The door is not fully closed or the
door lock is defective.
The demo mode is activated.
There is an electronic fault.
You left the dish in the oven for too
long.
The necessary data for the service centre is on the rat-
ing plate. The rating plate is on the front frame of the
appliance cavity.
Remedy
1. Fully close the door.
2. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and ac-
tivate it again.
3. If the display shows F102
again, contact the service cen-
tre.
1. Deactivate the appliance.
2. Press and hold the button +.
3. When an acoustic signal
sounds, turn the knob for the
oven functions to the first func-
tion. Demo flashes in the dis-
play.
4. Turn the knob for the oven
functions to the off position.
5. Release the button +.
6. Turn the knob for the tempera-
ture clockwise three times.
The acoustic signal sounds
three times. The demo mode
is deactivated.
1. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and ac-
tivate it again.
2. If the display shows the error
code again, contact the serv-
ice centre.
Do not keep the dishes in the oven
for longer than 15 - 20 minutes after
the cooking ends.
.........................................
.........................................
.........................................
19