ZANKER KOB57602 Benutzerinformation Seite 16

Stainless steel or aluminium appliances:
Clean the oven door with a wet sponge only. Dry
it with a soft cloth.
Do not use steel wool, acids or abrasive materials, as
they can cause damage to the oven surface. Clean the
oven control panel with the same precautions.
Shelf supports
You can remove the shelf supports to clean the side
walls.
Removing the shelf supports
1
Pull the front of the
shelf support away from
the side wall.
Installing the shelf supports
Install the shelf supports in the opposite sequence.
The rounded ends of the shelf supports must
point to the front.
Pyrolysis
Warning! The appliance becomes very hot.
There is a risk of burns.
Caution! If a hob is installed with the appliance,
do not use it at the same times as the Pyrolysis
function. It can cause damage to the appliance.
1. Remove the removable shelf supports (if applica-
ble) and accessories from the appliance. Refer to
"Removing the shelf supports".
Caution! Do not let the removable shelf supports
stay in the appliance during the cleaning
procedure. There is a risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
16
2
1
2
Pull the rear end of
the shelf support away
from the side wall and re-
move it.
The cleaning procedure cannot start if you do not
close the oven door.
4. Set the function Pyrolysis. Refer to "Oven func-
tions".
5.
When flashes, press + or - to set the neces-
sary procedure:
– P1 - if the oven is not very dirty. The procedure
is 1 h long.
– P2 - if the oven is more dirty. The procedure is
1 h 30 min long.
6.
Press to start the procedure. You can use the
End function to delay the start of the cleaning.
When the oven is at the set temperature, the door
locks. The display shows the symbol
bars of the heat indicator.
To stop Pyrolysis before it is completed, turn the
knob for the oven functions to the off position.
When Pyrolysis is completed, the display shows the
time of day. The oven door stays locked. When the ap-
pliance is cool again, an acoustic signal sounds and the
door unlocks.
During the Pyrolysis the oven lamp is off.
Cleaning reminder
To remind you that Pyrolysis is necessary, PYR flashes
in the display for 10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder goes off the display:
• After the end of the Pyrolysis function
• If you press + and - at the same time while PYR
flashes in the display.
Oven lamp
Warning! Be careful when you change the oven
lamp. There is a risk of electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deactivate the
circuit breaker.
Put a cloth on the bottom of the oven to prevent
damage to the oven light and glass cover.
Always hold the halogen lamp with a cloth to prevent
grease residue from burning on the lamp.
and the