What To Do If - ZANKER KOB57602 Benutzerinformation

3
1 2
Make sure that you put the glass panels (1, 2 and 3)
back in the correct sequence. The middle panel (2) has
a decorative frame. The screen-printing zone must face
the inner side of the door. Make sure that after the in-
stallation the surface of the glass panel frame (2) on
the screen-printing zones is not rough when you touch
it.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not operate.
The Pyrolysis does not start. The
display shows C1.
The Pyrolysis does not start. The
display shows C3.
18
Make sure that you install the top panel in the seats
correctly.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child Lock is on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
The shelf supports are not re-
moved.
The door is not fully closed or the
door lock is defective.
Remedy
Activate the appliance.
Set the clock. Refer to "Setting the
time of day".
Make sure that the settings are cor-
rect.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child
Lock".
Do a check of the fuse. If the fuse is
released more than one time, con-
tact a qualified electrician.
Replace the oven lamp.
Remove the shelf supports.
Fully close the door.