Back-Jump Function Setting - RADEMACHER RolloPort SX5 DuoFern Originalbetriebsanleitung

10.9 Back-jump function setting

(can also be configured for RolloPort SX5 DuoFern via HomePilot®)
Function
After closing, the jump-back function relieves the
drive components by briefly moving in the opposite
direction (10 mm).
1. Press "P" for approx.
5 seconds.
4. Press "+", the display
is "1".
(1 = on = the back-jump
function is switched on)
2. Press "+".
(press several times if
necessary) until "9" is
displayed.
5. Press "P" in order to
store the setting.
3. Press "P", the display is "0".
(0 = off = factory setting)
6. Conclude programming
(see page 70 / Method 2)
or proceed with next setting.
EN
69