D) Installation Of The Middle Support Clip (13) - RADEMACHER RolloPort SX5 DuoFern Originalbetriebsanleitung

9.11 (C) Installation of the door bracket (8)
3. Screw the door bracket (8) tight to the frame
with the enclosed self-tapping hexagon screws
(8 x 15 mm).
4. Finally, fix the door connector (12) to the door
bracket (8) with the enclosed bolt (9).
NOTE!
◆ A straight door connector is supplied pre-mounted, and
this is permanently fixed to the rail.
◆ If you wish to use the bent door connector (12) enclosed
(depending upon your door particular configuration),
you must attach this with two hexagon screws (8 x 20)
to the straight door connector.
5. Finally, secure the bolt (9) by attaching the
securing bolt (11) to prevent it from slipping out.

9.12 (D) Installation of the middle support clip (13)

1. Fit the middle support (13) clip at a suitable
place, as near as possible to the middle point
between the door and the drive head.
Legend
13 = Centre suspension
14 = Hexagon screws (8 x 60 mm)
13
14
EN
12
8
9
61