Alarm Setting; Automatic Closing Time Setting - RADEMACHER RolloPort SX5 DuoFern Originalbetriebsanleitung

10.5 Alarm setting

(can also be configured for RolloPort SX5 DuoFern via HomePilot®)
If the alarm is switched on, the drive beeps if
the door is open for longer than 10 minutes.
The signal tone is emitted for 30 seconds every
10 minutes.
1. Press "P" for approx.
5 seconds.
4. Press "+", the display
is "1".
(1 = on = the alarm setting
is switched on)

10.6 Automatic closing time setting

(can also be configured for RolloPort SX5 DuoFern via HomePilot®)
NOTE!
Before the door closes auto-
matically, the drive beeps for 20
seconds. At the same time the
light flashes.
When the door starts closing, the
light shines durably and it beeps
permanently.
After the door has closed, the
drive ends the beeping and the
light remains on for a further 3
minutes.
66
To end the beeping:
Press the door control button to fully close the door.
2. Press "+"
(press several times if neces-
sary) until "5" is displayed.
5. Press "P" in order to
store the alarm setting.
1. Press "P" for approx.
5 seconds.
3. Press "P", the display is
"0".
(0 = off = factory setting)
3. Press "P", the display is "0".
(0 = off = factory setting)
6. Conclude programming (see
page 70 / Method 2) or pro-
ceed with next setting.
2. Press "+"
(if necessary press several times)
until "6" is displayed.
4. Press "+", the display is "1".
(1 = on = automatic closing
time = 30 seconds).
EN