Back-Jump Function Setting - Rademacher Rp-Sx5-900N-3 Bedienungsanleitung

Back-jump Function setting

After closing, the jump-back function relieves the
drive components by brie y moving in the opposite
direction (10 cm).
1. Press „+" .
(press several times if
necessary) until „9" is
displayed.
4. Press „P" in order to
store the alarm setting.
2. Press „P",
the display is „0".
(0 = o = factory setting)
5. Conclude programming (refer to page 66, method 2)
or proceed with next setting.
3. Press „+",
the display is „1".
(1 = on = the back-jump
function is switched on)
EN
65