9.7 Connect the door drive housing to the rail (90° drive assembling)
Alternative installation of the drive transversely to the rail.
4
NOTE!
The microswitch (3) must always be positioned at the
end of the rail. For this reason, the microswitch (3)
must be correspondingly moved if the drive is installed
transversely (see figure above).
1
2
5
3
Mortal danger due to electric shock when under-
taking any work on the microswitch (3).
◆ Arrange for a qualified electrician to move the
microswitch (3).
◆ The microswitch (3) may only be moved if the
system is fully de-energised.
◆ Always remove the mains plug and secure it to
prevent it being switched back on prior to under-
taking the work.
◆ Check that the system is de-energised.
EN
57