2000 Cycle Alarm Setting - RADEMACHER RolloPort SX5 DuoFern Originalbetriebsanleitung

10.6 Automatic closing time setting
(can also be configured for RolloPort SX5 DuoFern via HomePilot®)
5. Press "+" and select the
required closing time:
1 = 30 s 5 = 150 s
2 = 60 s 6 = 180 s
3 = 90 s 7 = 210 s
4 = 120 s 8 = 240 s
(maximum)

10.7 2000 cycle alarm setting

(can also be configured for RolloPort SX5 DuoFern via HomePilot®)
After a period of time in use, regularly check to
see whether the door is level when opening/
closing, and whether the spring has enough force
to raise the door.
Add a suitable amount of lubricant to all moving
parts regularly.
1. Press "P" for approx.
5 seconds.
4. Press "+", the display
is "1".
(1 = on)
6. Press "P" in order to
store the setting.
NOTE!
If this function is activated, after 2000 cycles the drive
will indicate with a short whistling tone at regular
intervals that door maintenance must be carried out.
To end the alarm tone
Switch the power off and back on again, or press the
"P" button for 5 seconds.
2. Press "+"
(if necessary press several
times) until "7" is displayed.
5. Press "P" in order to save
the setting.
7. Conclude programming
(see page 70 / Method
2) or proceed with next
setting.
3. Press "P", the display is "0".
(0 = off = factory setting)
6. Conclude programming (see
page 70 / Method 2) or
proceed with next setting.
EN
67