Important Notes After Installation; Attach Safety Notices With Warning Information; Establish Operational Readiness Of The Door; Programming - RADEMACHER RolloPort SX5 DuoFern Originalbetriebsanleitung

9.13 Important notes after installation

◆ Ensure that the mechanism is properly adjusted
and that the drive reverses when the door contacts
a 50 mm high object placed on the floor (for drives
incorporating an entrapment protection system
depending on contact with the bottom edge of
the door), see page 76.

9.14 Attach safety notices with warning information

Improper use results in an increased risk of
injury.
◆ Permanently fix the labels warning against en-
trapment in a prominent place or near any fixed
controllers.
◆ Permanently fix the label concerning the manual
release adjacent to its actuating member.
◆ Attach all labels so that they are clearly legible.

9.15 Establish operational readiness of the door

1. Move the door carefully, in order to engage the
profile slide.
2. Plug the mains plug into the socket and switch
on the electricity.
3. The light goes on and the unit gives a single beep
and the display shows '0' at regular intervals.

10. Programming

In order that the following settings are correctly
stored and executed, you must carry out a final
programming procedure according to page 70.
62
◆ Ensure that the drive prevents or stops the opening
movement when the door is loaded with a mass
of 20 kg, fixed centrally on the bottom edge of the
door. This applies especially to drives which can be
used with a door that has openings in the door leaf
larger than 50 mm in diameter.
EN