Setting End Points / Setting The Upper End Point; Setting The Lower End Point - RADEMACHER RolloPort SX5 DuoFern Originalbetriebsanleitung

10.1 Setting end points / setting the upper end point

Carrying out the instructions in the wrong
order when setting the end points will result
in malfunctions. Be sure to keep to the setting
order specified.
1. Press "P" for approx.
5 seconds.
4. Press "+" or
press "–".

10.2 Setting the lower end point

1. Press "+", the
display shows "2".
4. The door opens or
closes.
2. The drive beeps and
shows "1".
5. The door opens or
closes.
2. Press "P",
"2" flashes.
5. If the door has moved downwards to the required position,
press "P" to save the lower end point.
Correct setting order:
1. Set upper end point
2. Set lower end point
3. Press "P",
"1" flashes.
6. If the door has moved up-
wards to the required
position, press "P" to save
the upper end point.
3. Press "+" or
press "–".
EN
63