Installing The Flight Battery; Center Of Gravity; Transmitter Control Identification - Blade SR Bedienungsanleitung

Installing the Flight Battery

Use the included hook and loop material for mounting the Li-Po battery pack. We suggest installing the loop (fuzzy) material
on the battery pack and the hook material on the battery support. You should also use the included hook and loop battery
strap for the most secure attachment of the battery to the helicopter.

Center of Gravity

Once you have properly installed and secured the battery, check the helicopter's center of gravity. With the canopy installed,
lift the helicopter by the flybar with the flybar positioned perpendicular to the tail boom. Move the battery forward or
rearward as required to achieve a slightly nose down or perfectly level helicopter position. You should always check the CG
of your Blade SR before flying, especially if you are switching between different sizes and types of battery packs.
Level or Slightly
Downward Angle
Downloaded from www.Manualslib.com
Support by Flybar
10
manuals search engine

Transmitter Control Identification

Note: Before each flight ALWAYS turn the transmitter on before connecting the flight battery to the 2-in-1 unit. After each
flight, you should always disconnect the flight battery from the 2-in-1 unit before powering the transmitter off.
Mode 2
Rudder/Throttle
Functions
Rudder Trim
Throttle Trim
Mode 1
Rudder/Elevator
Functions
Rudder Trim
Elevator Trim
Aileron/Elevator
Functions
Aileron Trim
Elevator Trim
Aileron/Throttle
Functions
Aileron Trim
Throttle Trim
11