Herunterladen Diese Seite drucken

Introduction; Product Support; Warning; Additional Safety Precautions And Warnings - Blade SR Bedienungsanleitung

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Introduction

Your Blade
SR is the absolute best way to transition from flying a coaxial heli to a single-rotor CCPM machine with
®
confidence and, most importantly, success. It comes out of the box programmed to provide softer climb, pitch and roll
response around the center of stick movement. This, combined with the tough, two-piece main frame and lower head speed,
makes the Blade SR more forgiving and easier to master than most conventional CP helis. Plus, it's big enough to fly
outdoors even if there's a little wind.
But before you take that first flight, read through this manual thoroughly. It includes vital information on safely charging
the battery, proper pre-flight control checks and adjustments, and many other tips that will help make your first flight a
successful one.

Product Support

For assistance in charging, setting up, binding or operating your Blade SR, please see page 43 to contact the appropriate
Horizon Product Support office.

Warning

An RC helicopter is not a toy! If misused, it can cause serious bodily harm and damage to property. Fly only in open areas,
preferably at AMA (Academy of Model Aeronautics) approved flying sites, following all instructions.
Keep items that can get entangled in the rotor blades away from the main and tail blades, including loose clothing, pencils
and screwdrivers. Especially keep your hands away from the rotor blades.

Additional Safety Precautions and Warnings

As the user of this product, you are solely responsible for operating it in a manner that does not endanger yourself and
others or result in damage to the product or the property of others.
This model is controlled by a radio signal that is subject to interference from many sources outside your control. This
interference can cause momentary loss of control so it is advisable to always keep a safe distance in all directions around
your model, as this margin will help to avoid collisions or injury.
Never operate your model with low transmitter batteries.
Always operate your model in an open area away from cars, traffic or people.
Avoid operating your model in the street where injury or damage can occur.
Never operate the model out into the street or populated areas for any reason.
Carefully follow the directions and warnings for this and any optional support equipment (chargers, rechargeable battery
packs, etc.).
Keep all chemicals, small parts and anything electrical out of the reach of children.
Moisture causes damage to electronics. Avoid water exposure to all equipment not specifically designed and protected
for this purpose.
Never lick or place any portion of your model in your mouth as it could cause serious injury or even death.
Downloaded from
www.Manualslib.com
4
manuals search engine

Specifications

Length . . . . . . . . . . . . . . . . . . . . . . . 19.10 in (485mm)
Height . . . . . . . . . . . . . . . . . . . . . . . 6.90 in (176mm)
Main Rotor Diameter . . . . . . . . . . . . . 21.80 in (552mm)
Tail Rotor Diameter . . . . . . . . . . . . . . 3.20 in (82mm)
Weight with Battery. . . . . . . . . . . . . . 120 oz (340 g)
Main Motor . . . . . . . . . . . . . . . . . . . Brushless 3900Kv (installed)
Tail Motor . . . . . . . . . . . . . . . . . . . . Direct-Drive N60 (installed)
Battery . . . . . . . . . . . . . . . . . . . . . . 3S 11.1V 1000mAh Li-Po (included)
Charger . . . . . . . . . . . . . . . . . . . . . . 3-Cell 11.1V Li-Po
Power Supply . . . . . . . . . . . . . . . . . . AC to 12V DC, 1.5A (included)
Transmitter . . . . . . . . . . . . . . . . . . . HP6DSM 2.4GHz DSM 6-channel (included)*
Receiver . . . . . . . . . . . . . . . . . . . . . Spektrum AR6110e 2.4GHz DSM Microlite (installed)
On-Board Electronics . . . . . . . . . . . . 2-in-1 Mixer/ESCs (installed)
Servos . . . . . . . . . . . . . . . . . . . . . . DS75 Digital Sub-Micro (3 installed)
Gyro . . . . . . . . . . . . . . . . . . . . . . . . G110 Micro Heading Lock (installed)
* CCPM Helicopter programming is specific to Blade SR. Please do not attempt to use transmitter with any other
CCPM helicopter

Blade SR RTF Contents

Item
Description
Not Available Separately . . . . . . . . . . Blade SR RTF Airframe
EFLH1057 . . . . . . . . . . . . . . . . . . . . HP6DSM 6-Channel Transmitter, 2.4GHz DSM2: BSR
EFLB0997 . . . . . . . . . . . . . . . . . . . . 1000mAh 3S 11.1V 15C Li-Po, 20AWG JST/Balance
EFLC3105 . . . . . . . . . . . . . . . . . . . . 3S 11.1V Li-Po Balancing Charger, 0.8A
EFLC4000 . . . . . . . . . . . . . . . . . . . . AC to 12V DC, 1.5- Amp Power Supply
EFLH1519 . . . . . . . . . . . . . . . . . . . . Micro Helicopter Main Blade Holder: BSR
EFLH1129 . . . . . . . . . . . . . . . . . . . . Mounting Accessories & Wrench
EFLH1528 . . . . . . . . . . . . . . . . . . . . Hook and Loop Material
EFLH1444 . . . . . . . . . . . . . . . . . . . . Hook and Loop Strap
FUG4. . . . . . . . . . . . . . . . . . . . . . . . 4 AA Batteries
No additional equipment is required to complete your Blade SR.
5

Quicklinks ausblenden:

Werbung

loading