Replacement Parts List; Optional Parts List - Blade SR Bedienungsanleitung

10. I will not operate my model aircraft while using any drug which could adversely affect my ability to safely control my
model aircraft.
11. Children under six (6) years old are only allowed on a flightline or in a flight area as a pilot or while under flight
instruction.
12. When and where required by rule, helmets must be properly worn and fastened. They must be OSHA, DOT, ANSI,
SNELL or NOCSAE approved or comply with comparable standards.
RADIO CONTROL
1. All model flying shall be conducted in a manner to avoid over flight of unprotected people.
2. I will have completed a successful radio equipment ground-range check before the first flight of a new or repaired model
aircraft.
3. I will not fly my model aircraft in the presence of spectators until I become a proficient flier, unless I am assisted by an
experienced pilot.
4. At all flying sites a line must be established, in front of which all flying takes place. Only personnel associated with flying
the model aircraft are allowed at or in front of the line. In the case of airshows demonstrations straight line must be
established. An area away from the line must be maintained for spectators. Intentional flying behind the line is
prohibited.
5. I will operate my model aircraft using only radio control frequencies currently allowed by the Federal Communications
Commission (FCC). Only individuals properly licensed by the FCC are authorized to operate equipment on Amateur Band
frequencies.
FREE FLIGHT
1. I will not launch my model aircraft unless I am at least 100 feet downwind of spectators and automobile parking.
2. I will not fly my model aircraft unless the launch area is clear of all individuals except my mechanic, officials, and other
fliers.
3. I will use an effective device to extinguish any fuse on the model aircraft after the fuse has completed its function.
CONTROL LINE
1. I will subject my complete control system (including the safety thong where applicable) to an inspection and pull test
prior to flying. The pull test will be in accordance with the current Competition Regulations for the applicable model
aircraft category. Model aircraft not fitting a specific category shall use those pull-test requirements as indicated for
Control Line Precision Aerobatics.
2. I will ensure that my flying area is clear of all utility wires or poles and I will not fly a model aircraft closer than 50 feet to
any above-ground electric utility lines.
3. I will ensure that my flying area is clear of all nonessential participants and spectators before permitting my engine to
be started.
Downloaded from www.Manualslib.com
38
manuals search engine

Replacement Parts List

Part # Description
EFLA308H . . . . . . 2-in-1 Helicopter Brushless ESC/Mixer
EFLB0997 . . . . . . 1000mAh 3S 11.1V 15C Li-Po, 20GA
JST/Balance
EFLC3105 . . . . . . 3-Cell Li-Po Balancing Charger, 0.8A
EFLC4000 . . . . . . AC to 12V DC, 1.5 Amp Power Supply
EFLH1057 . . . . . . HP6DSM 6-Channel Transmitter,
2.4GHz DSM2
EFLH1115 . . . . . . Bearing 3 x 6 x 2.5mm (2)
EFLH1143 . . . . . . Spindle
EFLH1146 . . . . . . Rotor Head Set
EFLH1148 . . . . . . Paddle Control Frame
EFLH1149 . . . . . . Flybar (2)
EFLH1150 . . . . . . Paddle Set
EFLH1151 . . . . . . Pitch Control Link Set
EFLH1163 . . . . . . Paddle Control Frame Pushrod Set
EFLH1165 . . . . . . Flybar Weight (2)
EFLH1171 . . . . . . Bell Mixer Main Blade Grip Set
EFLH1172 . . . . . . Bell Mixer Arm & Pushrod Set
EFLH1215 . . . . . . Bearing 4 x 8 x 3mm (2):
EFLH1319 . . . . . . Direct-Drive N60 Tail Motor Heat Sink
EFLH1322 . . . . . . Direct-Drive N60 Tail Motor
EFLH1323 . . . . . . Direct-Drive Tail Rotor Blade/
Prop Adapter
EFLH1324 . . . . . . Direct-Drive Tail Rotor Blade/Prop
EFLH1326W . . . . Stabilizer/Fin Set, White
EFLH1409 . . . . . . Pinion Gear, 9T 0.5M
EFLH1444 . . . . . . Hook and Loop Battery Strap
EFLH1501 . . . . . . Main Frame
EFLH1502 . . . . . . Landing Gear
EFLH1503 . . . . . . Tail Boom, Blue
EFLH1505 . . . . . . Direct-Drive Tail Motor Mount
EFLH1506 . . . . . . Horizontal Stabilizer/Fin Mount
EFLH1508 . . . . . . Main Shaft (2)
EFLH1509 . . . . . . Main Gear
EFLH1510 . . . . . . Main Shaft Retaining Collar
EFLH1511 . . . . . . Swashplate
EFLH1512 . . . . . . Center Hub
EFLH1513 . . . . . . O-Ring & Shim Set
EFLH1514 . . . . . . Hardware Set
EFLH1515 . . . . . . Servo Pushrod Set
EFLH1516 . . . . . . 3900Kv Brushless Motor
EFLH1517 . . . . . . Motor Mount
EFLH1518 . . . . . . 245mm Wood Main Rotor Blade
Set, White
EFLH1519 . . . . . . Micro Helicopter Main Blade Holder
EFLH1520 . . . . . . Blade SR Canopy, Blue
EFLH1522 . . . . . . Canopy Mount Asm
EFLH1524 . . . . . . Anti-Rotation Bracket/Guide
EFLH1525 . . . . . . Blade Grip Bolts
EFLRG110HL . . . . 11.0-Gram G110 Micro Heading Lock
Gyro
EFLRS75H . . . . . . 7.5-Gram DS75 Digital Sub-Micro
Helicopter Servo
SPMAR6110E . . . AR6110e DSM2 ML 6-Channel Receiver
End Pin, Air

Optional Parts List

Part # Description
EFLH1528 . . . . . . Hook & Loop Tape
EFLH1129 . . . . . . Mounting Accessories & Wrench
EFLH1410 . . . . . . Pinion Gear, 10T 0.5M
EFLH1504 . . . . . . Tail Boom, Black
EFLH1507 . . . . . . Tail Motor Wire Lead
EFLH1514 . . . . . . Hardware Set:
EFLH1521 . . . . . . Blade SR Canopy, Red
EFLH1523 . . . . . . Spindle/Feathering Shaft (2)
EFLH1527 . . . . . . Training Gear Set
39