Control Of Telemetry Devices - Siemens CKA4820 Betriebsanleitung

Operation
7.11

Control of Telemetry Devices

100
Siemens Building Technologies
Fire Safety & Security Products
PATTERN stop
PATTERN save
PATTERN test
Close OSD menu (save)
Telemetry devices which are addressed either
directly via COM2 of the control unit, or
via the TTY telemetry interface of SIMATRIX
can be controlled using the following functions:
1. Joystick mode digital
The motion speed of the telemetry devices is preset and cannot be controlled
with the joystick.
2. Joystick mode analog
The motion speed of the telemetry devices can be controlled using the joystick.
It increases gradually in proportion to the deflection of the joystick. For this
mode, all telemetry devices connected to the control unit must support variable
speed control (e.g. CCDA14xx Dome / SIVIS Minidome III ...).
If a dome system (CCDA14xxx or SIVIS Minidome III) is directly connected to the Com2 port of the
control unit (SIVIS / CCDA protocol), the telemetry devices are always controlled with variable speed.
01.2005