Interface Selection - Siemens CKA4820 Betriebsanleitung

Siemens Building Technologies
Fire Safety & Security Products
Selection of an AX address
If several SISTORE AX are connected to the same bus you can select the device
addresses using the following key combination:
Key sequence
press release
Numerical keys
To select SISTORE AX inputs use the following key combination on the control
unit:
Key sequence

Interface selection

To switch between interfaces use the following key combination on the control unit:
Key sequence
or
2
SISTORE AX may not be selected for connection to both interfaces COM1 and COM2 at the same
time.
If SISTORE AX is selected in the parameterization menu of the control units for both interfaces, then
an error message (! AX Error !!) appears on the display.
Switching between direct mode and telemetry mode
To switch between direct mode and telemetry mode press F1 (only if AX was
selected in the menu and is displayed on the LC display).
Description
Selection of SISTORE AX (here no. 5)
1. Keep AX key depressed (wait until a long signal tone can be heard),
keep on pressing AX key.
2. Press the desired numerical key (here no. 5).
3. Release AX key.
The new AX address is now saved in the control unit and it also
appears on the display.
Description
Selection of SISTORE AX input (here no. 5)
1. Press the desired key X (keys 1-9, 0; two-digit input is also possible:
00-99).
2. Press AX key.
The data is now transmitted and the selected channel is switched.
Description
Switching between interfaces
1. Keep POS key depressed.
2. Press either key 1 (interface 1) or key 2 (interface 2).
Operation
103
01.2005