Changing The Pin Code - Siemens CKA4820 Betriebsanleitung

Startup
6.3

Changing the PIN Code

84
Siemens Building Technologies
Fire Safety & Security Products
The PIN code can only be changed in the LOGIN status following input of the
administrator password.
1. Keep "MON" key pressed, press "F1" key. The LCD displays the following:
Parameterization menu
Basic parameters
The LED (15) flashes in orange.
2. Move joystick (1) downwards until the LCD displays the following:
Parameterization menu
Change PIN codes!
3. Move joystick (1) to right until the LCD displays the following:
Change PIN codes!
Change Administrator
If you wish to change the PIN code for User1: move joystick up or down until
the LCD displays the following:
Change PIN codes!
Change User1
4. Move joystick to right to "Change". The LCD displays the following:
PIN code input
PIN code: xxxx|xxxx|xxxx
The menu jumps back one level if a key is not pressed within 10 seconds of calling this function.
5. Enter the new number combination (9).
Max. 12 digits are permitted.
6. Press the key switch to confirm. The LCD displays the following:
Repeat PIN code input
PIN code: xxxx|xxxx|xxxx
7. Enter the new number combination again.
8. To accept the new PIN code, press the "Mem" key (10). If the two inputs are
the same, the LCD displays the following:
PIN code input accepted
otherwise:
PIN code input not accepted!
The LED lights up briefly:
LED lights up red: the PIN code has not been accepted.
LED lights up green: the PIN code has been changed.
PIN codes can only be changed with the administrator login. If the administrator password has been
forgotten, the unit must be returned to the servicing department.
01.2005