Parameterization; Key Assignments - Siemens CKA4820 Betriebsanleitung

7.4

Parameterization

7.5

Key Assignments

Siemens Building Technologies
Fire Safety & Security Products
Every function test can be exited using the F10 key.
Domes which are directly connected to the RS485 interface of the control unit can
also be parameterized. However, parameterization can only be carried out if the
dome is equipped with an OSD menu, and is suitable for operation with the control
unit. Data are not output via the COM1A/COM1B port in parameterization mode,
thus preventing double control.
You require the following keys to open or close the OSD menu of the dome. The
telemetry device selected last ("xxx"-"Cam"-"yyy"-"Mon" or just "xxx"-"Cam" with
operating mode "Telemetry devices connected directly to control unit", see Section
7.9) can also be parameterized using the following key combinations:
Keys
Keep pressed
Keep pressed
LED is blinking while Dome-OSD is activated by Cam+F1 and is not closed by Cam+F10.
The control unit keys are assigned as follows for the individual protocols:
Keys SCU/CCDA/SIVIS-DOME protocol
One menu level upwards (SIVIS)
One menu level downwards (SIVIS)
Special menu (SIVIS)
Zoom +/- Increase, decrease value (CCDAxxxx))
Focus Select value (CCDAxxxx)
You can obtain additional information on selection and navigation within the
parameterization menu from the corresponding Instruction Manuals of the
telemetry devices (especially telemetry in TTY mode).
Description
Switch on telemetry device operation, and open OSD menu
Switch off telemetry device operation, and close OSD menu
Operation
89
01.2005