Charging USB devices
CAUTION!
Use of the USB sockets
operation!
Ensure that the power consumption of the USB device is not
higher than 2.1 A if you are using just one of the USB sockets
. For more information, refer to the instruction manual
17
of your USB device.
If you are using both USB sockets
total power consumption of the connected USB devices may
not exceed 2.1 A!
Connect your USB device to one of the USB sockets
The battery symbol flashes on the USB connection panel
and indicates that your USB device is being charged.
4
Disconnect your USB device from the USB socket once it has
completely charged.
Manually activating signal reception
Activating DCF signal reception
Every night the main station synchronises the internal clock with
the DCF signal. However, you may also activate DCF reception
manually. To do so, press and hold the + / MEM
button
for 3 seconds until the radio tower symbol
9
Following successful reception the radio tower symbol will be static.
If reception fails, the radio tower symbol
60
GB/IE
is only possible during mains
17
simultaneously, the
17
will disappear.
.
17
and – / CH
10
flashes.