Changing The Radio Channel Display On The Weather Station - Auriol HG06061A-DCF Bedienungs- Und Sicherheitshinweise

Press and hold the – / CH button
flashes on the outdoor temperature panel
Press the TX button
radio signal. If reception is successful, the temperature and
moisture on the outdoor temperature panel
displayed on the new radio channel.
Close the battery compartment
Changing the radio channel display
on the weather station
If the weather station is receiving the outdoor sensor radio signal,
it will automatically display the appropriate channel.
However, you can also manually set the display of various radio
channels.
Press the – / CH button
displays CH1 (only display channel 1), CH2 (only display
channel 2), CH3 (only display channel 3) and
all channels alternately in a loop).
Note:
Only the values from outdoor sensors which are connected
to the weather station will be displayed.
If you are using several outdoor sensors you should select a
different radio channel for each outdoor sensor.
9
to manually initiate the outdoor sensor
22
25
repeatedly to switch between the
9
until the reception signal
.
3
will now be
3
again.
(display
GB/IE 59