Mountfield IBIZA Montageanleitung Seite 26

4.8.2 Skimmer
Punch the holes for the screws and then screw on the
flange by the crosswise pattern.
If the skimmer body was installed together with the
liner only now, put the double gasket into the opening
in the steel wall, hold the body from the outside and
make the openings for the screws on the inner side
and screw on the flange crosswise.
Now cut out the opening for the skimmer and put on
the flange cover. The top of the flange and the top of
the cover are normally marked "Top".
Insert the flap and sieve into the skimmer.
Fig. 80
Fig. 81
Fig. 82
Fig. 83
25
Fig. 84
Fig. 85
Fig. 86